Do any of you use an oxy-acet torch for exhaust work?

I've been looking into going MIG also but at this point, I wanted to master
the O/A setup I have. I've been turning out some decent beads with my torch
but I wanted to see about practical advice regarding folks that had used O/A
while under the car and on their backs, etc for vertical/inverted welds.

If it comes down to it, my friend had a Lincoln 175Plus in his shop that I
can likely get some time with.

Thanks and take care,
Andrew.



On 10/9/07 5:26 PM, in article u3sng351ev0ok5ri377g9tcnb5d91i32o0.TakeThisOut@4ax.com,
"djdave" <djdave.TakeThisOut@fake.com> wrote:

> Ive used coat hangers on the top of my amc gremlin fenders when I was
> a kid. They worked well.
> Any rental shops around you could rent a mig welder from? I bought one
> from harbor freight for 250 bux and L O V E it.
>
>
> On Sun, 07 Oct 2007 10:11:19 -0400, AWN
> <anixon1.TakeThisOut@REMOVETHEcogecoDOT.ca> wrote:
>
>> I have some exhaust work to do on an old project Nissan and I'm wondering if
>> any of you use gas torches for this? If so, what do you best suggest for
>> the filler? I've heard that coat hanger and bailing wire material works
>> well but I also have some rods kicking around. Do I need to grind the tubes
>> much??
>>
>> Thanks for any input you might have.
>> Andrew.
>
 >> Stay informed about: Do any of you use an oxy-acet torch for exhaust work?