Bill,
you need to remove the wiper motor cover located on the left side of the
firewall and rotate the gear so that it makes contact on the switch in the
proper position. But, before you do that, you need to remove the right side
knee bolster. There will be a wire that goes across from left to right with
a red fuse in the middle. Chances are this fuse blew at some point. usually
this fuse controls the return to the park position but not what the park
position is. In other words, this line keeps constant power to the motor so
that the wiper will always park in the same position as set by the gear
switch when the wiper is turned off on the steering wheel console
Webserve
"William Dennen" <ieee1014.TakeThisOut@hotmail.com> wrote in message
news:f32h0k$lk4$1@aioe.org...
> 1993 Jaguar XJ6, single center mounted windshield wiper
>
> How does one adjust the park position of the wiper? Is it really just
> undo the nut, reset to desired position, and you're (more or less) done?
>
> Went through an automatic car wash and at the other end the wiper had
> moved from its park position on the passenger (right) side to straight up
> the middle. Hmmm. Turned on the wiper and after a couple of swipes it
> settled down happily in full coverage. But now they're parking on the
> driver (left) side.
>
> Regards
> --
> >@<
> Bill Dennen wdennen.TakeThisOut@gmail.com
> Cluelessness: There are no stupid questions, but there are a LOT of
> inquisitive idiots. (despair.com)
>
FAQ
Profile
Private Messages
Log in
