Programming '02 Solara Remote

I know this has probably been "worn out" on here over time and I'm sorry but I
could not locate anything...Got a new remote (e-bay) for daughter's 2002 Toyota
Solara SE with factory remote entry/security system and need to program it.
FCC# GQ43VT14T
It has the three buttons on the front and the panic button on the back.
Any help will be greatly appreciated...Thanks in advance.

TJ

Program Remote for 2002 Camry (and perhaps other Toyotas with same
remote)
1. Start with the key out of the ignition, driver door open and
unlocked
2. Insert the key and take it out - twice within 5 seconds
3. Close and open the driver door - twice within 40 seconds
4. Jump out and run around the car once as fast as you can (optional)
5. Insert the key and take it out – once
6. Close and open the driver door - twice within 40 seconds
7. Insert the key and close the driver door
8. Turn the ignition to “On” hold it for 1 second, turn to “Off” (for
“Add” mode)
9. Remove the key
10. Hold down both “Lock” and “Unlock” at the same time for one second
11. Press “Lock” within 3 seconds.
(If the signal was recognized the locks will cycle once, if not they
will cycle twice.)

You can program a maximum of 4 remotes. Do a fifth and you’ll loose
the first.

To see how many are programmed: on step 7 switch between on and off
(holding 1 sec in each position) 3 times. The locks will cycle once
for each remote that is programmed.

To erase all programmed remotes: on step 7 switch between on and off
(holding 1 sec in each position) 2 times. (Say if you are replacing a
lost or stolen remote)

To erase all programmed remotes and disable the remote key entry system
all together: on step 7 switch between on and off (holding 1 sec in
each position) 5 times.


--
Big D
------------------------------------------------------------------------
Big D's Profile: http://www.usenetcars.com/member.php?userid=1330
View this thread: http://www.usenetcars.com/showthread.php?t=15199