Welcome to AutoForumz.com!
FAQFAQ      ProfileProfile    Private MessagesPrivate Messages   Log inLog in

306 1.4 '99 ECU question??

 
   car problems (Home) -> Peugeot RSS
Next:  Oil leak behind flywheel  
Author Message
Lozza




Joined: Apr 19, 2005
Posts: 1



(Msg. 1) Posted: Tue Apr 19, 2005 3:13 pm
Post subject: 306 1.4 '99 ECU question??

HI

Please help! I have had just about enough of my car. It's just come out of the garage after having a new heater matrix put in and a new head gasket which has cost me a packet.

Now it is not starting properly, jumpy when idle and stalling at traffic lights, it seems OK after a short while of driving and these problems are irratic. One other problem is it is not reaching high speeds as easily as before the new parts were put in. It has just been checked with a new coil pack, but has made no difference, does this mean it is the ECU?? or can this only be damaged if coil pack has gone??

If it is neither of these please can you tell me what else it may be as I am at my wits end.

Thanks in advance to anyone who can help!
Lozza

 >> Stay informed about: 306 1.4 '99 ECU question?? 
Back to top
Login to vote
Tonyh




Joined: Dec 13, 2004
Posts: 34



(Msg. 2) Posted: Wed May 18, 2005 6:11 am
Post subject: Re: 306 1.4 '99 ECU question?? [Login to view extended thread Info.]

Hi, unlikely to be ECU, recheck the valve timing, (thats been touched during repairs and would dramatically affect power and tick over).
Idler control valve not smooth ,clean up and lubricate, this no effect on power.
T

 >> Stay informed about: 306 1.4 '99 ECU question?? 
Back to top
Login to vote
Display posts from previous:   
Related Topics:
306 A/C question - A/C has stopped working on my 306Hdi (2001). I had the front pipe replaced last June and regassed and it worked fine after that. Now it's not working at all again. Anything obvious to look for before I take in for yet another pressure test? I'm sure that...

XUD7 question - A few questions on the XUD7 engine. 1. Has it got the ports for turbo charger oil feed pipes, and anything else that would be needed to fit a turbo? 2. What are those things round the back of the engine that look like blanked ports/holes? 3. Any way of....

Clutch question - Hi folks, I've got a Pug 307 2.0 HDi and the clutch has started to make a graunching noise (currently only noticeable in 1st gear and when the car is starting off uphill), last week it was at the top of the pedal travel as you are releasing the clutch..

1986 205 Swapping Engine Question - Hi All i have a 1986 Peugeot 205, 5 doors, and i wanted to make an engine swap for a 206 engine (1.6i one).. my question is, is the chassis of the 1986 205 can hold that engine or not ?? and what about the engine mountings ?? thanks in advance..!!

SATNAV Remote Question?????????? - Can anyone tell me if the sat/nav remote control has to be coded to the vehicle or are they interchangeable?? i have a 2002 406. Thank you.
   car problems (Home) -> Peugeot All times are: Pacific Time (US & Canada) (change)
Page 1 of 1

 
You can post new topics in this forum
You can reply to topics in this forum
You can edit your posts in this forum
You can delete your posts in this forum
You can vote in polls in this forum



[ Contact us | Terms of Service/Privacy Policy ]